The Pulsar Thermal Zeroing Targets are heated targets for simple and precise zeroing-in of a thermal imaging riflescope.
How to use:
- The heat pack is air-activated, do not open the pad packaging until you are ready to use it.
- Open the packaging and take out the heat pad.
- Note! Do not cut or damage the heat pad while taking it out.
- Remove the paper strip from the back side of the heat pad to expose the adhesive surface.
- Stick the heat pad with the adhesive side to the centre of the paper target marked with circle.
- Note! There is no need to shake the heat pad, it will warm itself up in 3-5 minutes.
- Attach the paper target to the desired location.
- Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize thermal view, so that thermal pad is clearly visible.
- Perform zeroing procedure as described in the user manual of your thermal imaging device.
- With the help of the round shape and small diameter of the pad, deviations of point of impact can be eliminated in just a few shots.
Features
- Carbon activated heating pads with adhesive side: 40 mm (heated surface)
- Paper Targets
- Heating Pads Remain hot for 10 – 20 minutes
- For use with your Thermal Imaging Scope
Specifications
| Quantity Targets | 10 pcs. paper |
| Target Size | 10 x 30 cm |
| Quantity Heating Pads | - 10 pcs. carbon activated heating pads |
| Duration of Pad Remaining Hot | 10-20 min, on cold surfaces (depends on weather conditions) |
| Ingredients | iron powder, activated carbon, vermiculite, salt, resin, water |
Reviews
There are no reviews yet.